Table of Contents
Advertisement
Turning on and turning off your server
This section describes how to turn on and turn off the xSeries Hosting Appliance.
Turning on the xSeries Hosting Appliance
Statement 1:
DANGER
Complete the following steps to turn on the xSeries Hosting Appliance:
1. Plug the power cord of your xSeries Hosting Appliance into the power source.
2. Wait 30 seconds, and then press the power control button on the front of the
18
IBM Eserver xSeries Appliances: Installation Guide for xSeries Hosting Appliance
Electrical current from power, telephone, and communication cables is
hazardous.
To avoid a shock hazard:
v Do not connect or disconnect any cables or perform installation,
maintenance, or reconfiguration of this product during an electrical storm.
v Connect all power cords to a properly wired and grounded electrical outlet.
v Connect to properly wired outlets any equipment that will be attached to
this product.
v When possible, use one hand only to connect or disconnect signal cables.
v Never turn on any equipment when there is evidence of fire, water, or
structural damage.
v Disconnect the attached power cords, telecommunications systems,
networks, and modems before you open the device covers, unless
instructed otherwise in the installation and configuration procedures.
v Connect and disconnect cables as described in the following table when
installing, moving, or opening covers on this product or attached devices.
To Connect:
1. Turn everything OFF.
2. Attach all cables to devices.
3. Attach signal cables to connectors.
4. Attach power cords to outlet.
5. Turn device ON.
Note: Plugging the power cord into a power source might cause the xSeries
Hosting Appliance to start automatically.
xSeries Hosting Appliance.
To Disconnect:
1. Turn everything OFF.
2. Remove power cords from outlet.
3. Remove signal cables from connectors.
4. Remove all cables from devices.
Advertisement
Table of Contents
