Advanced Entry - Datamax a-class mark ii Operator's Manual

Step Action
Observe the calibration
G
result.
Press the ESC Key
H repeatedly to exit menu
mode.

5.2.2 Advanced Entry

Advanced Entry will override all previous calibration settings and should only be

used when Standard Calibration attempts fail. Ensure that the correct SENSOR
TYPE is selected (see Section 4.2.1) before staring this procedure.
Advanced Entry is an alternate calibration method for special-case media types, where sensor
readings are taken using different sampling algorithms and from a list of these readings the best
algorithm is selected for manual entry into the database. Follow the steps below to perform an
Advanced Entry Calibration:
Step Action
A Turn ON the printer.
(continued)
76
Displayed Message
CALIBRATION COMPLETE
CALIBRATION COMPLETE
Followed by...
READY
Displayed Message
CANNOT CALIBRATE
-or-
UNCALIBRATED
Comment
Calibration was
successful.

If 'Warning Low
Backing' is displayed,
calibration was
successful (for
possible messages
see Section 5.1).
When calibrating gap or
reflective media, press
and hold the FEED Key
until at least one label is
output.
The printer is now ready
for use.
Comment
Wait briefly for the printer
to initialize.
A-Class