Datamax a-class mark ii Operator's Manual page 72

Hide thumbs Also See for a-class mark ii:
Table of Contents

Advertisement

Communications (continued)
Menu Item
CNTRL-CODES (DATA)
ENABLED
DISABLED
STX-V SW SETTINGS
ENABLED
DISABLED
MAX LENGTH COMMAND
ENABLED
DISABLED
OPTION FEEDBACK
DISABLED
SCANNER
RFID HEX
RFID ASCII
62
Determines how host Control Codes are handled,
where:
Processes software commands normally.
Controls the setting via the menu; see CONTROL
CODES, above.
Determines how a host option enable command is
handled, where:
Processes the command normally.
Controls settings via the menu; see Section
4.2.3.
Determines how a host Maximum Label Length
(<STX>M) command is handled, where:
Processes software commands normally.
Controls the setting via the menu; see Section
4.2.1.
Allows feedback characters from an optional
device to be returned to the host device, in the
format of <A;B;C;D;E;F>[CR], where:
A - Is the device type: R = RFID; and, S = Linear Scanner
B - Is the status: C = entire label complete; F = faulted
(failed) label; and, U = unknown
C - Is the number of expected reads, given in two
characters.
D - Is the number of good reads, given in two characters.
E - Is the internal Job and Sub Job Identifier, given in four
characters each.
F - Is the data read, delimited with semicolons (;) if
multiple reads.
Reports no data.
Reports Linear Scanner data.
Reports RFID data in hexadecimal format.
Reports RFID data in an ASCII format.
Details
A-Class

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the a-class mark ii and is the answer not in the manual?

Table of Contents