Datamax a-class mark ii Operator's Manual page 63

System Settings (continued)
Menu Item
FAULT HANDLING
LEVEL
NO REPRINT
STANDARD
VOID AND RETRY
DELAYED SCAN FAULT
A-Class
Determines the label disposition and user action if
a fault occurs, where:
Sets the printer response upon declaration of a
fault, where:
Stops printing and declares a fault. Then,
following correction of the problem, the FEED Key
must be pressed to clear the fault.
Stops printing and declares a fault. Then,
following correction of the problem, the FEED Key
must be pressed to clear the fault and reprint the
label in process.
Actions depend upon the RETRY COUNT:
• If the count has not been exceeded, VOID is
printed on the failed label and reprinting
automatically occurs;
• If the count has been exceeded, printing stops
and a fault message is displayed. Then,
following correction of the problem, the FEED
Key must be pressed to clear the fault and
reprint the label in process; or,
• If the CANCEL Key is pressed, reprinting is
optional: press NO to reprint; or, press YES to
cancel the reprint (and press YES again to
cancel the batch.)
 Linear Scanner or RFID required.
Increases throughput when bar codes reside near
the trailing edge of the label (in the direction of
FEED).
 Linear Scanner or RFID required.
If unreadable, the fault will occur after the
•
next label prints;
The label immediately following a faulted label
•
is not scanned for errors; and,
VOID AND RETRY and REPRINT are
•
automatically disabled; the job can only be
cancelled.
Details
53