Warning And Fault Messages - Datamax a-class mark ii Operator's Manual

General Resolutions (continued)
If experiencing this
problem...
Poor print quality:
Skips labels when
printing:

6.1.2 Warning and Fault Messages

The printer displays messages when the possibility of a problem or an actual fault occurs.
Depending upon the displayed message, find the possible action or solution in the tables
below.

Warning and Fault Messages do not appear when in Menu or Test Mode.
Warning Messages
Displayed for about three seconds, Warning Messages assume a low priority and indicate
a pending change in printer configuration, or an operating condition that could lead to a
fault.
108
Check the following possibilities:
Check the Leveling Cam for correct adjustment (readjust if
•
necessary; see Section 5.3.1);
Review the print quality controls (adjust if necessary; see
•
Section 3.5);
If using thermal transfer, check the media and ribbon
•
compatibility (use a recommended combination; see
Section 7.2); or,
Check for a dirty Printhead (clean it if necessary; see
•
Section 5.6.1).
Check the following possibilities:
Calibrate the printer (see Section 3.4);
•
Adjust the Media Sensor (see Section 3.2); or,
•
If the label format is within 1/8 inch of the media's edge,
•
reduce or move the format slightly away.
Try this solution...
A-Class