Cleaning Exterior Surfaces; Reset Methods; Soft Reset; Level One Reset - Datamax a-class mark ii Operator's Manual

5.6.5 Cleaning Exterior Surfaces

Clean the printer surfaces as follows:
1. Turn OFF and unplug the printer.
2. Using a soft cloth or sponge dampened with cleanser, wipe the exterior surfaces clean.
3. Allow the surfaces to dry.
4. Plug in and turn ON the printer.

5.7 Reset Methods

There are three reset levels for the printer.

5.7.1 Soft Reset

Soft Reset clears temporary host settings. To perform a Soft Reset, press and hold the CANCEL Key
(see Section 4.1) for approximately four seconds.

5.7.2 Level One Reset

The Level One Reset returns the factory default settings, or if saved a Factory Setting File. To
perform a Level One Reset, select SET FACTORY DEFAULTS (see Section 4.2.4).

5.7.3 Level Two Reset

The Level Two Reset returns the firmware default settings and clears all parameters. To perform a
Level Two Reset, press and hold the PAUSE, FEED, & CANCEL Keys while turning ON the printer
(see Section 4.1).

Calibration will be required; see Section 5.2.
A-Class 97