Datamax a-class mark ii Operator's Manual page 48

Printer Options (continued)
Menu Item
CUTTER
MODE
DISABLED
AUTO
ENABLED
CUT BEHIND
(0 – 2)
0
Ribbon Saver
DISABLED
AUTO
ENABLED
38
Controls the Cutter option, where:
Sets the detection method and response of the
printer, where:
Disables the option.
Detects, enables, and sets the label stop location
for the cutter; if not detected, the option will be
ignored.
Enables and sets the label stop location for the
cutter; if not detected, a fault will be generated.
Allows a number of small labels to queue before a
cut is performed, increasing throughput, where:
 This mode can be used without a cutter to
allow the presentation of an extra label, with
retraction occurring upon the next job or feed
operation.
Is the queue number.

After a fault or unknown label position, a
leading edge cut will be performed to ensure
against extra length on the first label;
otherwise, cutting will occur only as specified.
Controls the Ribbon Saver option, where:
Disables the option.
Detects enables the option. If not detected, the
option will be ignored.
Enables the option. If not detected, a fault will be
generated.
Details
A-Class