General Resolutions (continued)
If experiencing this
problem...
Poor print quality:
Skips labels when
printing:
6.1.2 Warning and Fault Messages
The printer displays messages when the possibility of a problem or an actual fault
occurs. Depending upon the displayed message, find the possible action or solution
in the tables below.
Warning and Fault Messages do not appear when in Menu or Test Mode.
Warning Messages
Displayed for about three seconds, Warning Messages assume a low priority and
indicate a pending change in printer configuration, or an operating condition that
could lead to a fault.
106
Check the following possibilities:
Check the Leveling Cam for correct adjustment (readjust if
•
necessary; see Section 5.3.1);
Review the print quality controls (adjust if necessary; see
•
Section 3.5);
If using thermal transfer, check the media and ribbon
•
compatibility (use a recommended combination; see
Section 7.2); or,
Check for a dirty Printhead (clean it if necessary; see
•
Section 5.5.1).
Check the following possibilities:
Calibrate the printer (see Section 3.4);
•
Adjust the Media Sensor (see Section 3.2); or,
•
If the label format is within 1/8 inch of the media's edge,
•
reduce or move the format slightly away.
Try this solution...
A-Class