Cleaning The Ribbon Path; Cleaning The Exterior Surfaces - Datamax I-Class Mark II Maintenance Manual

I-Class Mark II Maintenance Manual
2.4.4

Cleaning the Ribbon Path

If equipped with the Thermal Transfer option, as ink accumulates on the Ribbon Path components, smooth
ribbon flow can be impeded causing wrinkling. To prevent problems, clean the Ribbon Path components as
follows:
1. Turn OFF and unplug the printer. Raise the cover.
2. Raise the Printhead Assembly then remove ribbon.
Ribbon Shield
3. Using a cotton swab dampened with isopropyl alcohol, wipe the Ribbon Idler and the Ribbon Shield clean.
4. Allow the components to dry then replace the ribbon. Lower and latch the Printhead Assembly.
5. Close the cover. Plug in and turn ON the printer. Feed several labels to normalize tracking.
2.4.5

Cleaning the Exterior Surfaces

When soiled, clean the outer surfaces of the printer with a general-purpose cleanser. (Never use abrasive
cleansers or solvents.)
1. Turn OFF and unplug the printer.
2. Using a soft cloth or sponge dampened with a general-purpose cleanser to wipe the exterior surfaces
clean.
3. Allow the surfaces to dry.
Adjustments and Maintenance
Ribbon Idler
26