Unify OpenScape Desk Phone IP 55G User Manual page 103

Enhanced phone functions
Reconnect
Disconnect
Retrieving a held call
Press the corresponding line key. The line key LED lights up. The call is re-
trieved.
The LED display
Page 35 indicates to other multi-line telephones on which this line is

also configured that the call is on hold. These phones can then pick up the
call.
Held call wait status
After placing a call on hold, you can replace the handset and then decide wheth-
er to retrieve the call or disconnect.
Prerequisite: You placed a call on hold and replaced the handset or pressed
the loudspeaker key in speakerphone mode.
A recall follows immediately and a pop-up menu appears on the display:
Confirm with the softkey to retrieve the held call in speakerphone mode.
or
Confirm with the softkey to disconnect the held call.
If you enabled "Hold and hang-up" (
for a defined time interval (
with a recall to retrieve the call or disconnect. You can however retrieve the
call or disconnect via the softkeys "Reconnect" and "Disconnect" before
the defined time expires.
This function is not considered on multi-line phones.
Page 25 or status display on the "Overview" tab

Page 105), the call is placed on hold

Page 104) before the prompt is displayed

103