Enhanced Functions; The Following Features Are Not Supported; Recording Tips; Multiline - Unify OpenScape Desk Phone IP 55G User Manual

Call recording 239

Enhanced functions:

1
1. A conference can be set up or cleared down during recording.
2. A consultation can be performed during recording.
3. Call transfer is also available during recording.
4. A second call can be accepted during recording.

The following features are not supported:

1. Playing back recordings over the telephone.
2. Deleting recordings over the telephone.
3. Functions for editing recordings over the telephone.

Recording tips

You will receive the following advisories while a call is being recorded:
|
• The recording symbol on the display (permanent)
• Beep (repeated at intervals for you and your call partner)
• Beep (single at the start of recording for you and your call partner)
The audible advisory can also be switched off. Please check with the adminis-
trator.

MultiLine

There is no difference between multi-line calls and single-line calls when it
comes to recording calls. If recording has started, the call is recorded, otherwise
not. The recording status of a line continues as long as calls are connected to
this line.
For example, if line A is being recorded (initiated manually) and you switch to
line B or line A is placed on manual hold and you switch to line B, the recording
is ended and a partial recording saved.
If you disable recording for the call on line B (mode = manual or autostart) and
switch back to line A, the recording for line A is not started again.
The operating modes mentioned (All Calls, AutoStart or Manual) refer to the tele-
phone and are therefore the same for all lines.

Recording calls

Using the call recording feature

The recording function can be used in a similar way to a recorder, for example
for recording music. The recorder can be:
• Switched on (standby)
• Switched off or stopped
• Started
• Paused
1. Server-based conference only