Using Autodial Delay - Unify OpenScape Desk Phone IP 55G User Manual

118
User
Configuration
Outgoing calls
Autodial delay
5
Save & Exit

Using autodial delay

A number is automatically dialled after a set delay starting from the entry of the
number's last digit. The autodial delay can be used:
• when dialling in idle mode
• when deflecting an incoming call
• when conducting a consultation
• when transferring an answered call.
The delay can be reduced by performing one of the following activities:
• Pressing the key
• Lifting the handset. This only works if the phone number was entered when the
phone was idle or if it was entered for a consultation call when the handset was
off hook.
• Pressing the loudspeaker key. This only works if the phone number was en-
tered when the phone was idle and the loudspeaker key was not illuminated
or if the phone number was entered for a consultation call and the loudspeaker
key was not illuminated.
If an emergency number is preset by your administrator, the autodial delay
for this phone number is reduced to one second.
Settings for autodial delay
z
You can also configure this setting via the WBM interface
The setting does not affect automatic emergency number dialling.
If you select Autodial delay, you must either confirm with the softkey "Dial",
press the loudspeaker key or wait until the autodial delay expires to set up a call
when dialling with the handset on hook.
Press the key shown until the "Settings" tab is active.
Services
Confirm the option shown.
j
Enter and confirm the user password.
if nec.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Select a value between 1 and 9 and confirm.
Select the softkey to confirm.
Automatic dial delay does not work if you are using a dial plan and Imme-
diate dialling is configured (see
dialled as soon as the string entered matches an entry in the dial plan.
. This always works.
OK
Page 63). The number is automatically

Enhanced phone functions
Page 247.
