Table of Contents
Advertisement
Adapter
Note: Refer to "Handling Static-Sensitive Devices" on page 4-14 before removing or
installing adapters.
Removal
1. Remove the power supply or cooling unit located above the adapter you are removing.
Refer to the "Power Supply or Cooling Unit" removal procedure on page 4-61.
2. Do the "Adapter Cable" removal procedure on page 4-73 for the adapter you are
removing.
3. Loosen the thumbscrew on the adapter you are removing.
Note: If you are removing the SCSI-2 adapter, disconnect the SCSI-2 cable from the top of
the SCSI-2 adapter.
4. Reach through the access opening above the adapters, and then lift both ends of the top
of the adapter until the adapter disconnects from the slot.
5. Remove the adapter from the I/O module.
Rear View of CPU Enclosure
Access Opening
(Power Supply and Cooling Unit Removed)
Adapter
Cable
1/1
Thumb
1/2
Screw
(16)
Adapter Locations
Replacement
Replace in the reverse order.
1/3
1/5
1/7
1/4
1/6
1/8
SCSI-2 Adapter Location
0/1
0/3
0/5
0/7
0/2
0/4
0/6
Adapter Locations
Removal and Replacement
0/8
4-75
Advertisement
Table of Contents
