Table of Contents
Advertisement
Set Configuration
This command is used to configure electronic boards like I/O cards or Micro Channel
adapter (MCA) devices.
1. Enter 2 in the SET PARAMETERS menu to display the SET CONFIGURATION menu as
shown below:
SELECT [x:exit]:
2. Select the card or adapter of your choice by entering the appropriate command number.
A second-level screen lists available devices. For example, enter 2 to select Micro
Channel adapter (MCA) devices and display a screen listing available adapters, similar to
the following:
SELECT [x:exit]:
3. Select the particular device which you want to configure. A third-level screen is
displayed. For example, for adapter 0 (zero), you should see a screen similar to:
PRESENT CONDITIONS: Valid & Enable
COMMANDS: 0> BASIC MCA ADAPTER ENABLE
SELECT [x:exit]:
4. Enter your choice in the SELECT field.
Phone Numbers
This command is used to set various service support phone numbers.
2-34
Service Guide
SET CONFIGURATION
0> CPU CARD
1> MEMORY CARD
2> BASIC MCA ADAPTER
3> EXPANSION MCA ADAPTER
0> BASIC MCA ADAPTER #0
1> BASIC MCA ADAPTER #4
2> BASIC MCA ADAPTER #5
3> BASIC MCA ADAPTER #6
BASIC MCA ADAPTER #0
1> BASIC MCA ADAPTER DISABLE
2> BASIC MCA ADAPTER TEMPORARY DISABLE
BASIC MCA ADAPTER
Advertisement
Table of Contents
