Connecting An Lc-Sc Cable Adapter To A Device - IBM TotalStorage DS4000 EXP700 Installation, User's, And Maintenance Manual

Connecting an LC-SC cable adapter to a device

Complete the following steps to connect an LC-SC fibre channel cable adapter to a
device:
Statement 3:
CAUTION:
When laser products (such as CD-ROMs, DVD drives, fiber optic devices, or
transmitters) are installed, note the following:
v Do not remove the covers. Removing the covers of the laser product could
v Use of controls or adjustments or performance of procedures other than
DANGER
1. Read the information in "Handling fiber-optic cables" on page 35.
2. Connect one end of an LC-LC cable to an SFP module in the DS4000 EXP700.
3. Remove the two protective caps from the LC connector end of the LC-SC cable
Figure 31. Removing the LC-SC cable adapter protective caps
40
IBM TotalStorage DS4000 EXP700 and EXP710 Storage Expansion Enclosures: Installation, User's, and Maintenance Guide
result in exposure to hazardous laser radiation. There are no serviceable
parts inside the device.
those specified herein might result in hazardous radiation exposure.
Some laser products contain an embedded Class 3A or Class 3B laser
diode. Note the following.
Laser radiation when open. Do not stare into the beam, do not view directly
with optical instruments, and avoid direct exposure to the beam.
For instructions, see "Installing SFP modules" on page 32.
adapter as shown in Figure 31. Save the protective caps for future use.