Table of Contents
Advertisement
3. Once you have selected the test groups, you can specify individual tests within a group.
For example, the following screen enables you to specify individual BUMP Quick IO
tests:
GROUP 01 BUMP QUICK IO
TEST
01
03
05
07
09
11
13
51
53
COMMANDS: nn> SELECT TEST
SELECT [x:exit]:
Attention: Do not run tests from the above list on items that do not exist on your system, a
failure indication results.
4. Select a particular test by entering the test number. The selected test is included in the
list with default parameters.
Notes:
1. Use the slash ( / ) character to separate different tests. For example, enter 01/03
2. Use the * (asterisk) character to select all available tests.
3. Attempting to add tests to a full test list causes an error message to be displayed.
2-30
Service Guide
DESCRIPTION
DEBUG LINE
S2 ASL (REMOTE)
FLASH EPROM CONTENT
EPROM CONTENT
FLOPPY-DISK CONTROLLER
MISC REGISTERS
VPD COHERENCY
BPP EXTERNAL L-B FULL
AUTODIAL
* > ADD ALL TEST TO TEST LIST
to specify tests 1 and 3 with default parameter values.
BUILD TEST LIST
TEST
02
04
06
08
10
12
50
52
54
DESCRIPTION
S1 ASL (BUMP)
S3 ASL (SPECIFIC)
NOVRAM CONTENT
TOD
BPP REGISTERS
CPU ACCESS
ASL EXTERNAL L-B
PRINTER
BPP EXTERNAL L-B
Advertisement
Table of Contents
