Table of Contents
Advertisement
power-off with a power distribution bus, 4-2
power-on from BUMP console, E-3
power-on procedure with power distribution panel,
4-11
power-on using the power-on button, E-4
power-on with a power distribution bus, 4-4
power-off procedure with a power distribution unit,
4-5
power-on procedure a power distribution unit, 4-7
R
rail, 1-16
rail installation, 1-16
rails, CPU enclosure, 6-16
rear access plate, 4-60
rear connector locations with rear access plate
removed, 1-4
reference information, 1-1
related publications, xiii
removal and replacement procedures, 4-1
3.5-inch diskette drive, 4-23
adapter, 4-75
adapter cable, 4-73
CD-ROM drive or optional media device, 4-18
CPU module, 4-39
CPU module fans, 4-50
CPU module flex cables, 4-57
disk drive, 4-17
front bezel and front access plate, 4-15
handling static-sensitive devices, 4-14
I/O module, 4-67
I/O module flex cables, 4-76
I/O planar power cables, 4-77
I/O planars, 4-78
interlock cable, 4-43
lateral planar 1 card, 4-56
lateral planar 2 card, 4-71
lithium battery, 4-21
media module, 4-27
media module fans, 4-30
media module internal cables, 4-32
memory card, CPU card, or I/O card, 4-45
memory SIMM, 4-49
operator panel, 4-20
operator panel bezel, 4-25
power distribution cables, 4-79
power supply, 4-61
power supply fan, 4-64
power-off procedure with a power distribution
panel, 4-9
power-off with a power distribution bus, 4-2
power-on procedure with a power distribution
unit, 4-7
power-on procedure with power distribution
panel, 4-11
power-on with a power distribution bus, 4-4
power-off procedure with a power distribution
unit, 4-5
rear access plate, 4-60
system interface board (SIB), 4-65
system planar, 4-52
S
safety notices, xi
service inspection guide, 1-19
Service Line Speed Parameter, 2-37
Set Mode to Normal when Booting Flag, 2-36
setting voltage margins, 2-20, 2-33
SIB (system interface board), 4-65
specifications, 1-17
system interface board (SIB), 4-65
system planar, 4-52
system planar connector locations, 1-8
system power states, E-1
SystemGuard
BUMP overview, 2-2
common tasks, 2-39
authorize the service console, 2-43
boot from network, 2-52
boot from SCSI device, 2-49
disable processors, 2-55
enable processors, 2-55
enable surveillance, 2-46
reboot AIX from remote service console, 2-48
set fast IPL, 2-40
set the electronic key, 2-39
set the service line speed, 2-42
set up console mirroring, 2-44
set up dial-out feature, 2-46
components, 2-2
console mirroring, 2-44
consoles, 2-4
dial-in phone numbers, modifying, B-5
dial-out authorization flag, modifying, B-4
dial-out phone numbers, modifying, B-5
electronic key, 2-4
X-5
Glossary
Advertisement
Table of Contents
