5. Record the location of the flex cable connectors.
6. If you are removing the flex cable connected to the horizontal connector on the I/O card,
remove the two large slotted mounting screws.
If you are removing the flex cable connected to the vertical connector on the I/O card,
remove the two guide pin mounting screws.
Attention: To prevent damage to the pins, do not use pliers to remove the two guide pin
mounting screws, use an open-end wrench.
7. Remove the fan located above the flex cable connector you are removing. Refer to the
"CPU Module Fans" removal procedure on page 4-50.
Flex Cable
Connectors
Guide Pin
Mounting
Screws
4-58
Service Guide
Large Slotted
Mounting Screws
CPU Module
Two Fans Are Shown Removed