Table of Contents
Advertisement
Receiver assignment
Fixed-wing models
Installation instructions
The servos must be connected to the
receiver in the indicated sequence. Outputs
that are not required are simply not assigned.
Please note following for the mz-18 HoTT transmit-
ter:
By default, the 9-channel mz-18 HoTT
transmitter can only control outputs 1 to 9. Any
servos that are connected to outputs 10 to 12
remain in their neutral position with this transmitter.
Follow the instructions on the subsequent pages.
Fixed-wing models with and without a motor with up
to 4 ailerons and up to 4 flaps ...
... and a normal tail unit or 2 elevator servos
Free or right flap 2 or aux. function
Free or left flap 2 or aux. function
Free or 2nd elevator or aux. function
Free or right aileron 2 or aux. function
Receiver power supply
Right flap or free or aux. function
Flap or left flap
Right aileron or aux. function
Rudder
Elevator or 1st elevator
Aileron or left aileron
Airbrake or throttle servo
or speed controller (electric motor)
Receiver power supply
Free or left aileron 2 or aux. function
40
Receiver configuration - Airplane models
... and a V-tail
Free or right flap 2 or aux. function
Free or left flap 2 or aux. function
Free or aux. function
Free or aux. function
Receiver power supply
Right flap or free or aux. function
Flap or left flap
Right aileron or aux. function
Right rudder / elevator
Left rudder / elevator
Aileron or left aileron
Airbrake or throttle servo
or speed controller (electric motor)
Receiver power supply
Free or aux. function
Delta/flying wing models with and without a motor
with up to 4 ailerons/elevators and 4 flap/elevator
servos
Free or aux. function or right flap 2 / elevator
Free or aux. function or left flap 2 / elevator
Free or aux. function
Free or aux. function
Receiver power supply
Free or right flap / elevator
Free or left flap / elevator
Free or aux. function
Free or rudder
Right elevon
Right elevon
Airbrake or throttle servo
or speed controller (electric motor)
Receiver power supply
Free or aux. function
Due to the different installation of the servos and rudder
linkages, the operating direction for certain servos may
be reversed. The following table offers assistance in this
regard.
Servo with wrong
Model
direction of
type
rotation
V-tail
Reversed rudder
Change the poles
and elevator
of servos 3 + 4
in the submenu
"REVERSE"
The rudder is
Switch servos 3 + 4
correct and the
on the receiver
elevator is reversed
The elevator is
Change the poles
correct
of servos 3 + 4
The rudder is
in the submenu
reversed
"REVERSE", and on
the receiver
Delta,
The elevator
Change the poles
Flying
and aileron are
of servos 2 + 3
wing
reversed
in the submenu
"REVERSE"
The elevator is
Change the poles
correct and the
of servos 2 + 3
aileron is reversed
in the submenu
"REVERSE", and on
the receiver
The aileron is
Switch servos 2 + 3
correct and the
on the receiver
elevator is reversed
All of the relevant menus for a fixed-wing model are
identified by an wing icon in the "Program descriptions"
...
... so that you only have to deal with these menus when
programming fixed-wing models.
Solution
Advertisement
Table of Contents
