GRAUPNER S1005 Programming Manual page 54

Changing the support point value
• X-axis button
Activate this function by touching the button at
the bottom edge of the display with a finger or the
provided stylus.
You can then move an active (red) point to the
right by pressing the button, or to the left by
INC
pressing the button, for example:
DEC
NORMAL
WIZ.
Pitch min. BACK
Curve OFF
IN 000%
OUT 000%
POINT 2
ST ON X-axis Y-axis
Touch the button again to deactivate the
X-axis
function.
Note:
• If you move the red point horizontally
away from the current control
position, the point soon becomes
green and a "?" appears in the POINT line.
This question mark does not relate to the point
which has been moved but rather indicates
that another point can be set at the current
control position.
• Remember that the percentages in the "IN"
and "OUT" line always refer to the momentary
position of the control stick and not to the
position of the point.
• Y-axis button
Activate this function by touching the button at
the bottom edge of the display with a finger or the
provided stylus.
You can then move an active (red) point upward
by pressing the button, or downward by
INC
54
Basic menu - Model selection
pressing the
(X-axis)
Pitch min.
TRIM
Touch the
function.
INC
Note:
DEC
000%
ENT
and not to the position of the point.
Rounding off the channel 1 curve
• ON/OFF button in the "Curve" line
The default angled curve profile can be
automatically rounded off by turning on the
rounding function by pressing this button with a
finger or the provided stylus, for example:
Pitch min.
(Y-axis)
button, for example:
DEC
NORMAL
WIZ.
BACK TRIM
Curve OFF
IN –044% INC
OUT +027%
POINT 2 +044% DEC
Y-axis
ST ON X-axis ENT
button again to deactivate the
Y-axis
Remember that the percentages in the
"IN" and "OUT" line always refer to the
momentary position of the control stick
NORMAL
WIZ.
BACK TRIM
Curve OFF
IN 0 % INC
Touch
OUT +027%
POINT 2 +044% DEC
ST ON X-axis Y-axis ENT
NORMAL
WIZ.
Pitch min. BACK
Curve ON
IN –044%
+027%
OUT
POINT 2 +044%
ST ON X-axis Y-axis
Important note:
The curves portrayed here are for
demonstration purposes only and do not
represent real pitch curves.
Additional functions
• TRIM button
The mz-18 HoTT and mz-24 HoTT transmitters
have a function that is integrated in the transmitter
program for trim up to six support points of the
two options "throttle curve" and "pitch curve"
during flight.
Open the following window by touching the
button at the top right edge of the display with a
finger or the provided stylus:
WIZ.
CTL MIXER POINT Q.LINK
NONE NONE L 1
NONE NONE L 1
NONE NONE L 1
NONE NONE L 1
NONE NONE L 1
NONE NONE L 1
TRIM
INC
DEC
ENT
TRIM
INC
RES
DEC