GRAUPNER S1005 Programming Manual page 121

BACK Graubele
RECV
RX FAIL SAFE <>
OUTPUT CH: 04
GENE
>INPUT CH: 01
MODE : FAI SAFE ELEC
F.S.POS : 1500µsec
VARIO
DELAY : 0:25sec
GPS
FAIL SAFE ALL: NO
POSITION : 1500µsec
ESC
In this case, servo connector 04 reacts according to the
fail safe settings of CH 01.
The reaction time or delay set in the "DELAY" line
contrastingly applies uniformly to all channels set to
"FAI(L) SAFE".
RX FREE MIXER
ESC
BACK
DEC
RX FREE MIXER
>MIXER
INC
MASTER CH: 00
ENT
SLAVE CH : 00
S-TRAVEL–:
SET
S-TRAVEL+:
RX WING MIXER
TAIL TYPE: NORMAL
Value Explanation
MIXER Mixer selection
MASTER CH Signal source or
source channel
SLAVE CH Target channel
S-TRAVEL– Mixing on the
"–" side of the
servo travel in
percentage servo
travel
S-TRAVEL+ Mixing on the
"+" side of the
servo travel in
percentage servo
travel
RX WING Tail type
MIXER
TAIL TYPE
Graubele
RECV ESC
<>
: 1
GENE DEC
ELEC INC
100
VARIO ENT
100
GPS SET
ESC
Possible settings
1 ... 5
0, 1 ... depending
on the receiver
0, 1 ... depending
on the receiver
0 ... 100 %
0 ... 100 %
NORMAL,
V-TAIL
ELEVON
(elevator/aileron
mixer for delta and
flying wing)
Function menu - Telemetry | SETTING & DATA VIEW
MIXER
Up to five mixers can be programmed. In the "MIXER"
line, select one of mixers 1 ... 5:
The following settings in this display only relate to the
mixers selected in the "MIXER" line.
Important note:
If you have already programmed mixer
functions in the "Wing Mix" or "programm-
able mixers" menus, pay special attention
to ensure that these mixers do not overlap with
those in the "RX FREE MIXER" menu!
MASTER CH
According to the same principles described in the
section "programmable mixers" on page 72, the
signal at MASTER CH (signal source or source channel)
can be mixed with the SLAVE CH (target channel) to the
adjustable amount.
Select "00" if you not wish to set any mixer.
SLAVE CH
The signal of the MASTER CH (signal source or source
channel) is proportionately mixed with the SLAVE CH
(target channel). The level of mixing is determined
by the percentages entered in the "TRAVEL–" and
"TRAVEL+" lines.
Select "00" if you not wish to set any mixer.
(level of mixing in %)
TRAVEL–/+
With the settings of these two lines, the percentage of
mixing is specified in relation to the MASTER signal
separately for both directions.
RX WING MIXER TAIL TYPE
The following model types are also available in the base
menu of a model and should preferably be preset there.
In this case, always leave the TAIL TYPE at NORMAL.
If you still want to use the mixers integrated in the
receiver, you can then select the preset mixer functions
for the corresponding model type:
("from")
("to")
(tail type)
121