Table of Contents
Advertisement
Charging using automatic chargers
To fast charge the transmitter battery, Graupner auto-
matic chargers can be used. The following table offers a
selection.
Recommended chargers (accessories)
Name
6411
Ultramat 8
x
x
x
6463
Ultramat 12 plus
x
x
6464
Ultramat 14 plus
x
x
x
6466
Ultra Trio plus 14
x
x
x
6468
Ultramat 16S
x
x
x
6469
Ultra Trio Plus 16
x
x
x
6470
Ultramat 18
x
x
x
6475
Ultra Duo Plus 45
x
x
6478
Ultra Duo Plus 60
x
x
x
6480
Ultra Duo Plus 80
x
x
For charging the transmitter battery, the charging cable with
order No. 3022 is required, and for charging the receiver battery,
the charger cable with order No. 3021 is required.
Other chargers as well as details on the listed chargers can be
found in the main Graupner FS catalogue or on the Internet at
www.graupner.de.
First plug the banana plugs of the charging
cable into the charger, and then plug the
other end of the charging cable into
the transmitter charging socket. Never connect the
bare ends of the plugs of a charging cable that is
already connected to the transmitter!
16
Description of the transmitter - General operating instructions
To prevent damage to the transmitter, the charging
current should generally not exceed 1.5 A. Limit the
charge current if necessary.
Removing the transmitter battery
To remove the transmitter battery, first remove the cover
of the battery compartment on the back of the transmit-
Suitable for
ter.
the following
battery types
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
Then disconnect the transmitter battery plug by carefully
pulling the supply cable. Then lift the battery and pull it
gently off of the velcro.
(The display shows the battery for the transmitter
mz-24 HoTT.)
Inserting the transmitter battery
The battery connector is protected by two bevelled
edges from polarity reversal when plugging in. The free
socket of the battery connector faces upward at the
bottom of the battery compartment as can be seen in
Battery connecting plug
the following picture. The plus pole (red cable) is in the
middle, and the minus pole (brown or black cable) is on
the side facing the battery.
Never forcefully insert the plug into the socket on the
transmitter board.
Then place the battery into the compartment, and close
the battery cover.
Battery operating time in the bottom left display
The time (green) is automatically reset to 0:00 once the
transmitter battery voltage is recognizably higher than
the most recent voltage after the transmitter is started,
and the display shows the cumulative operating time of
the transmitter since last charging.
000%
000:00.0
000
000
mz
000:00.0
0:01:23
M 1
000
000
NORMAL
MODEL NAME 1
BATT TIME 00: 01: 23
000
000%
4.2V
000
Advertisement
Table of Contents
