No Delay Ch; Wing Set; Wing Set Detail - GRAUPNER mz-32 HoTT Reference Manual

Graupner mz-32 Help Reference Manual
Tapping on the Trim field for a control surface will activate the edit toolbar where the trim
value for each phase can be assigned. Make sure you have the phase active for which you
want to enter a new value.
permits to toggle between the global and phase-dependent setting.
Tap on the Non-delay checkbox to select a channel (check mark) for the exclusion of a
previously assigned delay for the active flight phase (displayed in top center of screen).
F03S1
mix or control surface setting by tapping on the respective Ctrl field.
F04S1
set as global the mix will be permanently active unless a control is assigned to turn the mix
on or off.
Note: The Act/Action icon and Ctrl assignment in this section is the same as in the main
Wing Set section.

NO DELAY CH

In the No Delay Channel menu, you can exclude
channels from being affected by a previously set delay
during phase switching.
For example, you may have a phase where the ailerons
and flaps have a certain offset and to ensure a smooth
transition the phase has a delay setting. However, you
may want the ailerons to be excluded from the delay
when a specific phase is activated.
The channel number is displayed in the No column. The
Function column displays the channel name.
Tapping the Group icon for the respective channel

WING SET

In the Wing Set menu you can activate and deactivate
various mixes between the wing control surfaces, set
rates for control surface deflections and the sensitivity
of trims.
The Function column lists the name of available control
surface mixers and control surfaces. Tapping on a
Function field will graphically highlight (red arrows) the
affected channels on the Detail Set image.
Tap on the respective Act icon to activate or deactivate
a mix or control surface setting, .
You can assign a switch (Input Control) to activate a

WING SET DETAIL

Tapping on the Detail Set image will provide additional
settings for control surface rate and trim sensitivity.
The available
mixer/channel has been chosen.
In the Wing Set Detail menu you will set the rates for
each of the control surfaces that are part of the mix.
Each mix can be global or phase dependent. Tapping
the Group icon toggles between the global and phase-
dependent setting.
The mix can be activated by tapping on the Action icon
which will enable the mix for that phase. If the mix is
Page 18 of 42
settings vary based
Help-Ref-EN-V1.0
on what