Table of Contents
Advertisement
BACK
Graubele
NORMAL
4
7
10 11 12
1
2
3
5
6
8
9
–100%
–061%
+100%
000%
000%
000%
+100%
+061%
000%
000%
000%
To go to the "base menu", leave the "Servo display" by
touching the
button at the top left:
BACK
Important:
In contrast to the "CH Set" menu, all the
settings of this menu refer to the relevant
servo independent of where the control signal
for the servo comes from , i.e., either directly from the
control element or from mix functions.
Example of a servo limit:
The rudder servo is controlled directly from its control
and, for reasons of comfort, also from an "aileron >>
rudder" mix.
For model-specific reasons, the rudder servo can only
follow a maximum servo travel of 100% since the rudder
would contact the elevator if it were to travel more than
100%.
As long as only the rudder is used, this is not a problem.
It becomes a problem, however, if the signals add up to
a total travel of more than 100% when simultaneously
using the rudder and the aileron. The linkages and
servos can be subject to an extreme load ...
To prevent this, the path of the relevant servo should
be limited individually. In the case of the rudder servos
used here as an example, this would be slightly less
than 100% since we are assuming that the rudder is
already traveling 100%.
VIEW
000%
Basic menu - Servo path/servo limit
67
Advertisement
Table of Contents
