Table of Contents
Advertisement
Important:
•
If you forget to assign a control in the
PUPIL transmitter, the relevant servo(s)
remain in middle position after
transferring control functions to the PUPIL
transmitter.
•
Independent of the type of RF link of the TEACH
transmitter to the model, the PUPIL transmitter
should always be operated in normal PPM mode.
Trainer mode
Both transmitters are connected to each other using an
appropriate cable (see the overview on the next page).
Insert the plug identified as "M" (master) in the socket
of the TEACH transmitter, and insert the plug with "S"
(student) (depending on the available cable) in the
socket of the PUPIL transmitter.
Important instructions:
•
Before starting trainer mode for the
operational model, be sure to check
whether all the functions have been
correctly transferred.
•
Do not insert an end of your trainer cable
identified with "S" or "M" with a 3-pin jack
plug into a socket of the DSC system. It is not
designed for this purpose. The DSC socket can
only be used for cables with a 2-pin jack plug.
Trainer cable
for trainer mode between any two Graupner
4179.1
transmitters with a DSC socket which can
be identified by a 2-pin jack plug on both
ends.
Trainer cable to connect a TEACH transmit-
3290.7
ter having a DSC socket (such as an mx-12
to
mc-32
HoTT transmitter, or a transmit-
ter retrofitted with the optional DSC module
- order No. 3290.24) to a Graupner PUPIL
transmitter with a PUPIL socket for the opto-
electronic system - identifiable by the "S" on
the side of the three-pin jack plug.
Trainer cable to connect a PUPIL transmit-
3290.8
ter having a DSC socket (such as an mx-12
to
mc-32
HoTT transmitter, or a transmit-
ter retrofitted with the optional DSC module
- order No. 3290.24) to a Graupner TEACH
transmitter with a TEACH socket for the op-
toelectronic system - identifiable by the "M"
on the side of the three-pin jack plug.
Additional information on the cables and modules
mentioned in this section for the TEACH and PUPIL
transmitters can be found in the relevant transmitter
instructions in the main Graupner FS catalogue, and on
the Internet at www.graupner.de.
109
Function menu - Trainer
Advertisement
Table of Contents
