GRAUPNER S1005 Programming Manual page 91

Servo test
Note:
Only start a servo test in a model memory
created for this purpose without any mixer.
Otherwise, unforeseeable servo deflections
will occur.
To activate the servo test function, use a finger or the
provided stylus to touch the field at the top right:
VIEW
NORMAL
BACK Graubele
1 2 3 4 5 6 7 8 9 10 11 12
–100% –061% +100% 000% 000% 000%
+100% +061% 000% 000% 000%
Additional buttons appear at the right edge of the
display:
NORMAL
BACK Graubele
1 2 3 4 5 6 7 8 9 10 11 12
–100% –061% +100% 000% 000% 000%
+100% +061% 000% 000% 000%
To change the default cycle time of 0.5 seconds, touch
the corresponding value field. The color of the field
switches from grey to blue:
BACK
1 2 3
– 00% –061%
+100%
In the blue value field, the time for a movement cycle
can be changed at 0.5 s steps between 0.5 and a
VIEW
maximum of 5.0 seconds with the
at the right edge:
Touch
BACK
1 2 3
000%
– 00% –061%
+100%
TEST
Touch the
RES
active field to the default of 0.5 seconds.
+0.5s
Start the servo test by touching the
INC
bottom right:
RES
DEC
BACK
OFF
1 2 3
000%
– 00% –061%
+100%
Graubele NORMAL
4 7 10 11 12
5 6 8 9 TEST
+0.5s
INC
RES
DEC
+100% 000% 000% 000%
OFF
+061% 000% 000% 000% 000%
or button
INC DEC
NORMAL
Graubele
4 5 6 7 8 9 10 11 12 TEST
+4.0s
INC
RES
DEC
+100% 000% 000% 000%
OFF
+061% 000% 000% 000% 000%
button to reset a changed value in the
button at the
OFF
NORMAL
Graubele
4 5 6 7 8 9 10 11 12
TEST
+4.0s
INC
RES
Touch
D C
+100% 000% 000% 000%
OFF
+061% 000% 000% 000% 000%
The "Servo test" function automatically controls the
servos operating under the assumption that the
associated controls (starting from the neutral position)
will be simultaneously and continuously moved back
and forth between -100% and +100% during the set
period. All of the servos that are active in the model
memory move within the set servo paths and servo path
limits until the servo test is stopped by touching the
button at the bottom right:
NORMAL
BACK Graubele
1 2 3 4 5 6 7 8 9 10 11 12
–100% –061% +100% 000% 000% 000%
+100% +061% 000% 000% 000%
Touch the button at the top left of the display to
BACK
leave this menu and return to the base menu.
BACK BASE FUNCTION
Model Type Rev/Slow
Model Sel E.P A
Motor TX ctl Timer Fail Safe
Servo CH Set Out.Swap
Basic menu - Servo
ON
TEST
+4.0s
INC
Touch
D C
ON
000%
SYSTEM
Sub-Trim
Trim Step
91