System Setup
Link a Microphone Over the Network
To improve device management from a central help desk or
technician station, a microphone can be linked to any group
on the network using a remote charging station. Using a
control system, send the command strings* to replace a
microphone for a specific channel. Group settings are not
affected by this procedure.
1. Connect a spare charger to the network.
2. Place the microphone in a charging slot.
3. Modify the following command string according to the
setup : <SET PRI x REMOTE_LINK y {zzz.zzz.
zzz.zzz} >
SET PRI x REMOTE_LINK y {zzz.zzz.zzz.zzz}
① PRI (primary) or SEC (secondary) channel link
② Charging slot number used for new microphone
③ Channel targeted for this procedure
④ IP address of the APT (device that stores the group
settings)
60
4. Send the command to the charger.
5. Verify the command response: <REP PRI x REMOTE_
LINK y {zzz.zzz.zzz.zzz} SUCCESS>
*A comprehensive list of MXW command strings are
available on the Shure website: http://shure.custhelp.
com/app/answers/detail/a_id/5207