Exchanging Or Removing A Component; Exchanging A Transmitter; Remove A Device From A Group - Shure Microflex Wireless User Manual

System Setup

Exchanging or Removing a Component

Exchanging a Transmitter

The same Link procedure is done to exchange a transmitter
in a group. Place the new transmitter in the charger slot
that corresponds to the desired channel and perform the
Link procedure. This will map the new transmitter to that
channel, and remove any Link from the old transmitter.
If an NCS channel slot is empty during the Link procedure,
the channel will remain unaffected.

Remove a Device from a Group

To remove a device from a group, open the MXW Control
Software and go to the Configuration tab. In the group
row, select the device drop-down window that contains
the desired device. Select 'none' to clear the device
association.
Note: A factory reset will also remove the any
association or Link status.
59
Important: Use caution when replacing microphones,
as the Link procedure applies for all microphones in
the charger. The Link will immediately override any
existing microphone's audio and RF connection to the
system.