Shure Microflex Wireless User Manual page 76

Software
Monitor Tab
① Access Point Selection
Determines which Access Point is displayed on the tab.
② Spectrum Meter
Opens the Spectrum Scanner window. See Scanning
Available RF Spectrum section for more details.
③ Global Mic Control
Controls the status of all microphones in the configuration
(all groups made from the Configuration tab).
④ Channel Name
Channel names are customizable and apply to any
linked microphone. The name persists even if a different
microphone is linked.
⑤ Microphone Link Slot
Selects the which microphone displays on the channel strip.
Note: One microphone is on-air per channel, though an alternate microphone can
be prepared in the secondary link slot.
⑥ Identify Button
Commands the microphone to beep and its LED to flash.
⑦ Microphone Status and Control
View or change the microphone state:
• Active: On and passing audio to the network.
• Mute: On but the audio is muted.
• External: On and passing audio to an external controller that
controls the mute/active behavior.
76
• Standby: On but in a 'sleep' state with audio muted. Standby
conserves battery charge and enables a change to the
microphone's status from the control software.
• Charging: Battery is charging.
• Inactive: Off or out-of-range. A microphone in this state
cannot be remotely controlled by the software.
• Power Off: Turn off the microphone.
⑧ Battery Status
• In the charger: Displays the remaining time until the
microphone battery is fully charged
• Out of the charger: Displays the remaining battery runtime
of the microphone.
⑨ RF Signal Strength
Indicates the signal strength of the microphone. When the
bars are grey, the microphone is out of range.
⑩ Audio Input Meter
Indicates the average input signal level.
Color Audio Signal Level (dBFS)
Red 0 to -9
Yellow -9 to -18
Green -18 to -60
⑪ Mic Gain
Adjusts microphone gain from -25 dB to +15 dB gain in 1
dB steps.
Description
Overload
Normal peaks
Signal Present