Shure Microflex Wireless User Manual page 64

Wireless Management
Performing a Scan
Follow these steps to perform RF scan.
Tip: Perform the scan during typical hours of
operation to best capture the typical interference in
an environment.
1. Ensure all typically used devices are turned on,
including any MXW equipment already in use.
2. Place the new MXW Access Point near the location it
will be mounted.
3. Ensure the APT is on the same network and set to the
same subnet as the other MXW equipment.
4. Open the Monitor tab of the MXW control software.
5. Make sure the new Access Point is selected from the
drop down on the top left corner of the Monitor tab.
64
6. Press the Spectrum Scanner button. The Spectrum
Scan window opens.
7. Press the Start Scan button at the top of the window. If
any microphones are Linked to that Access Point, they
will be turned off.
8. Allow the scan to run for up to 24 hours. Press End
Scan to end the scan mode.