Shure Microflex Wireless User Manual page 80

Software
⑭ Pending Changes Buttons
These buttons confirm or cancel any changes made to the
device properties:
Device Properties
Edit the settings for each device by opening the Device
Properties window from the Utility tab. Device properties
are edited individually, but are uploaded to the devices in
bulk by selecting the Apply All button. This ensures that
the changes are deployed properly across the network.
Some settings vary depending on the device capabilities.
APT Properties Window
① Device Name
Device names can be customized with up to 31 characters.
② Push to Dante Name
Uses the device and channel name from the MXW web
interface to overwrite the names in the Dante Controller
(DC) software by Audinate.
Note: Use with caution, as this could break the routing configuration previously
made in DC, causing audio interruptions.
③ Factory Reset
Resets the device to default settings, clearing any MXW
Group and Link associations. The password to access the
control software will reset to admin.
80
• Apply All: Confirms and executes all updates to device
properties. At this time, the computer may lose connection to
the control software.
• Cancel All: Clears all pending changes to the device
properties.
④ Serial Number
The unique identifier used to register the device at the
Shure website, guarantee the warranty, and troubleshooting
with customer support.
⑤ Interface Selection
View and adjust IP settings for the device's network
interface(s). Network settings are different for each device.
See the Networking section for configuring each MXW
device.
• Control: Shure control (software interface operation, firmware
updates, Shure Device Discovery application).
• Network Audio: Dante network audio (digital audio
networking and Dante software).
⑥ IP Mode
Sets IP mode of the selected network interface:
• Auto (DHCP): For automatic assignment of IP addresses.
• Manual (Static): For Static IP addresses.
⑦ IP Settings
View and edit the IP Address, Subnet Mask, and Gateway
for each network interface.
⑧ MAC Address
The network interface's unique identification.
⑨ Add Updates
Select Add Updates to save the device changes to
the control software. All device properties are updated
simultaneously from the Utility tab. Once saved, the device
will show Pending under the Properties column.
⑩ Cancel Updates
Remove any changes made to the device properties.