Automatic Group Setup - Shure Microflex Wireless User Manual

System Setup

Automatic Group Setup

An MXW Group can be associated without use of the control software when a network is comprised of only one Access
Point Transceiver (APT), one Networked Charging Station (NCS) and one Audio Network Interface (ANI). For best results,
perform a factory default on the devices to clear any previous Group associations.
1. Connect one APT, one NCS and one ANI to the network. The network must only contain one of each device.
2. Perform a factory reset on the devices (see the Factory Default section).
3. On the front panel of the ANI, press both input level selection buttons at the same time and hold for five seconds. The
Channel Select LEDs will illuminate green and the audio meter will flash to indicate that the association is successful.
50
12
11
1
10
9
8
5
7
6
+
link
link
2
push to solo | hold to mute
3
4
5
12
11
1
10
2
9 3
8
4
7 5
6
push to solo | hold to mute
push to solo | hold to mute
i i i i i i i i