Exchanging Or Removing A Component; Exchanging A Transmitter; Remove A Device From A Group - Shure MXW Series User Manual

Setting Up the System

Exchanging or Removing a Component

Exchanging a Transmitter

The same Link procedure is done to exchange a transmitter in a group. Place the new transmitter in the charger slot that corresponds to the desired channel
and perform the Link procedure. This will map the new transmitter to that channel, and remove any Link from the old transmitter.
If an NCS channel slot is not connected to a transmitter during the Link procedure, the channel and current transmitter Link will remain unaffected.
Important: Use caution when replacing microphones, as the Link procedure applies for all microphones in the charger. The Link will immediately override
any existing microphone's audio and RF connection to the system.

Remove a Device from a Group

To remove a device from a group, open the MXW Control Software and go to the Configuration tab. In the group row, select the device drop-down window
that contains the desired device. Select 'none' to clear the device association.
Note: A factory reset will also remove the any association or Link status.
30