Completing The Upgrade Process (S8300 Is The Primary Controller) - Avaya g700 Installation And Upgrades

Upgrade of an existing S8300B to R3.0 with manual upgrade of G700 firmware
Completing the upgrade process
(S8300 is the primary controller)
Telnet to the S8300 (primary controller) and open a SAT session:
1. To check media modules
2. To enable scheduled maintenance
3. To busy out trunks
4. To check for translation corruption
5. To resolve alarms
6. To re-enable alarm origination
7. To back up the system
8. To restart LSPs (if any)
To check media modules
1. Type list configuration all and press Enter.
2. Verify that the software is communicating with all media modules and that all media
modules are listed in the reports.
3. Make test telephone calls to verify that Communication Manager is working.
To enable scheduled maintenance
1. Type change system-parameters maintenance and press Enter.
2. Ensure that the Start Time and Stop Time fields' administration is the same as before the
upgrade.
To busy out trunks
1. Busy out trunks that were busied out before the upgrade (see
page 650).
To check for translation corruption
1. Type newterm and press Enter.
If you do not get a login prompt and see the following message:
Warning: Translation corruption detected
follow the normal escalation procedure for translation corruption before continuing the
upgrade.
684 Installation and Upgrades for Avaya G700 Media Gateway and Avaya S8300 Media Server
on page 684
on page 684
on page 684
on page 684
on page 685
on page 685
on page 685
on page 685
To record all busyouts on