Administering The Media Gateway - Avaya g700 Installation And Upgrades

Note:
The LSP node names must be administered on the node-names-ip form before
Note:
they can be entered on the LSP form.
To add LSP names to the LSP screen
1. At the SAT prompt, type change lsp to open the LSP screen.
LSP Screen
change lsp
Number NAME
1 node-10-LSP_
2 ____________
3 ____________
4 ____________
5 ____________
6 ____________
7 ____________
8 ____________
9 ____________
10 ____________
11 ____________
12 ____________
13 ____________
14 ____________
15 ____________
16 ____________
2. Enter the node name for each LSP supported by the primary controller.
3. Submit the form.

Administering the Media Gateway

To perform the procedures in this section, telnet to the primary controller, log in, and open a SAT
session.
!
CAUTION:
Before administering a media gateway, make sure that the gateway has been
CAUTION:
fully configured.
In this section, you will do the procedures:
To add a media gateway
To verify changes
LOCAL SURVIVABLE PROCESSOR
IP Address
192.168.1.50
out-of-service
out-of-service
out-of-service
out-of-service
out-of-service
out-of-service
out-of-service
out-of-service
out-of-service
out-of-service
out-of-service
out-of-service
out-of-service
out-of-service
out-of-service
Administer Communication Manager
Page 1 of
Service Translations
State? Updated
in-service 14:21 5/4/2003
Issue 8.1 June 2005
16
205