Installing Post-Upgrade Communication Manager Service Pack File From Your Laptop, If Any - Avaya g700 Installation And Upgrades

Installing post-upgrade Communication Manager
service pack file from your laptop, if any
Skip to Upgrade the G700 Firmware
service pack file to install.
!
CAUTION:
The service pack may or may not be call-preserving.
CAUTION:
To install post-upgrade Communication Manager
service pack file from your laptop
1. Click Start > Run to open the Run dialog box.
2. Type telnet 192.11.13.6 and press Enter.
3. Log in with the initial craft ID and password. (You cannot use dadmin at this point.)
4. Type cd /var/home/ftp/pub and press Enter to access the pub directory.
5. At the prompt, type ls -ltr and press Enter to list files in the pub directory.
The media server displays a list of files in the FTP directory. Verify that the directory
contains the Communication Manager .tar.gz file you have uploaded, if any.
6. Type sudo update_unpack <update>.tar.gz, and press Enter.
where <update> is the release or issue number of the latest service pack file. (For
example, 03.0.219.0-4925.tar.gz).
7. Type update_show and press Enter to list Communication Manager files.
Verify that the new software file was installed.
8. Type sudo update_activate <update>, and press Enter.
where <update> is the release or issue number of the latest software file. (For example,
03.0.219.0-4925. Do not use the .tar.gz extension at the end of the file name).
The system may initiate a software reset system 4. You must wait until the restart/reset
has completed before entering additional commands.
If the system displays the message,
/opt/ecs/sbin/drestart 1 4 command failed
ignore this message.
9. Type update_show again and press Enter to list Communication Manager files.
Verify that the new software file was applied.
on page 674 if there is no Communication Manager
Upgrade the S8300
Issue 8.1 June 2005 671