Avaya g700 Installation And Upgrades page 508

Media gateway and media server

Hide thumbs Also See for g700:

Table of Contents

Manual installation of a new G700 with an S8300

4. Complete the Network Region field with the value supplied in the planning documentation.

5. If specifically requested by the customer or your planning documents, type

gateway-announcements in the V9 field.

This field allows you to enable announcements on the G700 media gateway. V9 is a virtual

slot. There is no announcement board associated with it. The announcements for the G700

are available in the G700 firmware and are administered in the same way as

announcements on the TN2301 circuit pack used on S8500 or S8700 port networks.

If there are multiple G700 media gateways sharing announcements, then enable

announcements on the G700 whose trunks will receive the announcements most often.

6. Press F3 (Enter) to save your changes.

If properly administered, the G700 should register with the primary controller within 1–2

minutes. The IP Address, MAC Address, and Module Type fields are populated

automatically after the G700 media gateway registers with the server.

7. Type change media-gateway to view the Media Gateway screen.

Media Gateway screen (after registration with primary controller)

change media-gateway 1

Serial No: 012X06230551

Network Region: 1

Registered? y

The media modules installed in the G700 are listed next to their slot numbers. Verify that a

G700 media gateway has been successfully added.

508 Installation and Upgrades for Avaya G700 Media Gateway and Avaya S8300 Media Server

MEDIA GATEWAY

Name: Swainsons

IP Address: 135.9.41.150

FW Version/HW Vintage: 21.13.0 /0

MAC Address: 00:04:0d:02:06:ca

Encrypt Link? y

Controller IP Address: 135.9.41.146