About Log In Methods; Logging In To The Media Server From Your Laptop Using Telnet - Avaya g700 Installation And Upgrades

About Log in Methods

This section describes how to log on to the S8300, S8500, or S8700/S8710 media servers
using Telnet or the built-in Web Interface and how to start a SAT session. The last procedure in
this section describes logging in to the P330 Stack Processor when you have a direct serial
connection to the G700 Console port.
These procedures assume:
You have a crossover cable directly connected from your laptop to the Services port on the
●
media server, and your laptop is configured for a direct connection.
or,
You are connected to the S8300, S8500, or S8700/S8710 media server over the
●
customer's LAN, either remotely or on site.
In this case, your laptop must be configured to connect to the customer's LAN, and you
would use the LAN IP address of the S8300 instead of 192.11.13.6.

Logging in to the media server from your laptop using Telnet

To run telnet
1. Make sure you have an active Ethernet or serial connection from your computer to the
Media Server.
2. Access the telnet program.
For example:
a. On a Windows system, go to the Start menu and select Run.
b. Type telnet 192.11.13.6 to access the media server CLI.
3. When the login prompt appears, type the appropriate user name (for example, cust or
craft).
4. When prompted, enter the appropriate password.
5. If you log in as craft, you are prompted to suppress alarm origination.
Generally you should accept the default value (yes).
6. Enter your terminal type.
Accept the default value, or enter the appropriate type for your computer. For example, you
may use type ntt, a terminal type available for Windows NT4.0 or Windows 98. For
Windows 2000, use w2ktt.
7. If prompted for a high-priority session, typically answer n.
The system displays the telnet prompt. It may take the form <username@devicename>.
About connection and login methods
Issue 8.1 June 2005 61