Setting The Lsp Transition Points; Configuring An X330 Expansion Module (If Necessary) - Avaya g700 Installation And Upgrades
Media gateway and media server
Hide thumbs
Also See for g700:
- Installing and upgrading (808 pages) ,
- Installing manual (768 pages) ,
- Installation manual (494 pages)
Table of Contents
Advertisement
Manual installation of a new G700 with an S8300
The Gateway will have registered with the primary controller, if present. If the primary
controller is running and has been administered properly, the Registered field says YES
and the H248 Link Status says UP. If the controller is not running, the Registered field says
NO and the H248 Link Status says DOWN.
Setting the LSP Transition Points
You must set the length of time that the G700 searches, in the event of a network problem, for
primary controllers (for example, additional CLAN connections) with which to register. After this
search time has elapsed, the G700 will search for an LSP with which to register. You must also
set the total time the G700 searches for either a primary controller and an LSP, after which the
G700 resets. And finally, you must define how many primary controllers, from 1 to 4, are in the
controller list you just defined.
To set LSP transition points
1. At the MG-001-1(configure)# prompt, type set mgp reset-times primary-search
<search-time>
where <search-time> is the time in minutes that the G700 searches for a primary
controller before looking for an LSP. The range is from 1 to 60.
2. At the MG-001-1(configure)# prompt, type set mgp reset-times total-search
<search-time>
where <search-time> is the total time in minutes that the G700 searches for both primary
controllers or LSPs. The range is from 1 to 60.
3. At the MG-001-1(configure)# prompt, type set mgp reset-times
transition-point <#_of_primary>
where <#_of_primary> is the number of primary controllers in the controller list. If the
primary controller is an S8500 or S8700, the range is from 1 to 4. If the primary controller is
an S8300, <#_of_primary> must be 1.
Configuring an X330 Expansion Module (If Necessary)
User Guides and Quick Start Guides for the expansion modules are available on the Avaya
Support web site:
To obtain the appropriate Avaya Support Web site document
1. Go to the Avaya Support web site: http://avaya.com/support.
2. In the list on under Technical Database, click on LAN, Backbone, and Edge Access
Switches.
3. Under Wiring Closet & Distribution, click on P330 Stackable Switching.
484 Installation and Upgrades for Avaya G700 Media Gateway and Avaya S8300 Media Server
Advertisement
Table of Contents
