Avaya g700 Installation And Upgrades page 699

mm712v58.fdl, and
<tftp_server_ip_address> is the ip address of the S8300.
Two or three minutes will be required for most upgrades. The VoIP media module upgrade
takes approximately 5 minutes. Screen messages indicate when the transfer is complete.
5. After you have upgraded all the media modules, verify that the new versions are present.
At the MG-???-1(configure)# prompt, type show mg list_config
The list of software appears.
Show MG list_config
SLOT TYPE CODE
---- ------ -----
V0 G700 DAF1
V1 ICC S8300
V2 DCP MM712
V3 ANA MM711
V4 DS1 MM710
6. In the TYPE column, find the particular media module (v1 through v4), then check the
matching field in the FW VINTAGE column to see if it matches the planning documentation.
Note:
Slot V1 can contain either a media module or the S8300, which will show as
Note:
TYPE ICC.
7. Check the VOIP FW column and row for slot v0 to see if the number matches the VoIP
firmware identified in the planning documentation.
8. Type reset <module #>
where <module #> is the number of the G700 in the stack.
9. When the reset is finished, type show mm to verify the upgrade.
To release board (if media module was busied out)
1. When the upgrade procedure is complete, go to the SAT session and release the board
Type release board vx
where x is the slot number of the upgraded media module.
2. Verify the response,
Command Successfully Completed
Install new firmware on the G700 Media Gateway
SUFFIX HW VINTAGE
------ ----------
A 00
A 00
A 2
A 3
A 1
FW VINTAGE VOIP FW
---------- -------
21.25.0(A) 26
5 N/A
5 N/A
16 N/A
8 N/A
Issue 8.1 June 2005 699