Administering Network Regions - Avaya g700 Installation And Upgrades

Installing a new G700 with an S8300

Administering Network Regions

Before assigning an IP network region to a G700, you must define network region on the IP
Network Region form. After a network region is defined, you can assign it to the various network
elements (servers, gateways, IP phones).
The information you need to do this should be provided in your planning documentation. Use
the system defaults if the planning documentation does not specify otherwise.
For a G700 with an S8300 as primary controller, there will usually be one network region,
defined as 1. The procedure below uses 1 for the network region number as an example but the
procedure applies for any network region number from 1 to 250.
To define IP network region 1
!
CAUTION:
Defining IP network regions can be quite complex. For detailed information on
CAUTION:
the use and administration of IP network regions, see ''Administration for Network
Connectivity for Avaya Communication Manager, 555-233-504.''
1. At the SAT prompt, type change ip-network-region 1.
The S8300 displays the IP Network Region screen.
IP Network Region Screen
change ip-network-region 1
Region: 1
Location:
Name:
MEDIA PARAMETERS
Codec Set: 1
UDP Port Min: 2048
UDP Port Max: 3028
DiffServ/TOS PARAMETERS
Call Control PHB Value: 34
802.1P/Q PARAMETERS
Call Control 802.1p Priority: 7
H.323 IP ENDPOINTS
H.323 Link Bounce Recovery? y
Idle Traffic Interval (sec): 20
Keep-Alive Interval (sec): 5
162 Installation and Upgrades for Avaya G700 Media Gateway and Avaya S8300 Media Server
Home Domain:
Audio PHB Value: 46
Audio 802.1p Priority: 6
Keep-Alive Count: 5
IP NETWORK REGION
Intra-region IP-IP Direct Audio: yes
Inter-region IP-IP Direct Audio: yes
IP Audio Hairpinning? y
RTCP Reporting Enabled? n
RTCP MONITOR SERVER PARAMETERS
Use Default Server Parameters? y
AUDIO RESOURCE RESERVATION PARAMETERS
Page 1 of 19
RSVP Enabled? n