Avaya g700 Installation And Upgrades page 483

Note:
For an S8500 or S8700/S8710 primary controller, the last three IP addresses in
Note:
the list can be either the addresses of C-LANS (which are connected to the same
S8500 or pair of S8700/S8710s that act as primary controllers) or addresses of
LSPs. If you enter a combination of both, you must list C-LANs first and the LSPs
last, after the C-LANs.
2. Type reset mgp at the MG-???-n(configure)# prompt to reset the G700 media gateway
processor.
A system prompt asks you to confirm the reset.
3. Select Yes at the dialog box that asks if you want to continue.
The G700 media gateway processor resets. The LEDs on the G700 media gateway and the
media modules flash. These elements each conduct a series of self-tests. When the LEDs
on the media modules are extinguished and the active status LEDs on the G700 media
gateway are on, the reset is complete.
The system ultimately returns you to the P330-1 (configure) prompt.
At the P330-1(configure)# prompt, type session mgp.
At the MG-001-1(super)# prompt, type configure to change to the configuration mode.
Note:
Because the G700 media gateway has registered with its primary controller, the
Note:
prompt name has changed; for example, to MG-001-1.
Type show mgc to display the list of available servers and their IP addresses.
For example:
Show Call Controller Status Screen
MG-001-1(configure)# show mgc
CALL CONTROLLER STATUS
------------------------------------------
Registered
Active Controller
H248 Link Status
H248 Link Error Code: 0x0
MGC List Management : Static
CONFIGURED MGC HOST
--------------------
135.9.71.95
- Not Available --
- Not Available --
- Not Available --
: YES
: 135.9.71.95
: UP
DHCP SPECIFIED MGC HOST
-----------------------
-- Not Available --
-- Not Available --
-- Not Available --
-- Not Available --
Configure the G700 Media Gateway
Issue 8.1 June 2005 483