Connecting An Isdn Bri Station To An Mm720 Media Module - Avaya g700 Installation And Upgrades

Connecting an ISDN BRI station to an MM720 Media Module

Each ISDN port on the MM720 Media Module (see
two ISDN BRI stations.
Note:
The MM720 BRI Media Module cannot be administered to support both BRI
Note:
trunks and BRI stations at the same time. Also, the MM720 BRI Media Module
does not support combining both B-channels together to form a 128-kbps
channel. Finally, if the MM720 BRI Media Module is administered to support BRI
stations, it cannot be used as a clock synchronization source.
To connect one ISDN BRI station to one ISDN port:
1. Connect the station via a standard 8-pin BRI cable to one of the ISDN ports on an MM720
Media Module.
To connect two ISDN BRI stations to one ISDN port:
1. Connect each station to an RJ-45 splitter that provides two RJ-45 4-pair jacks, and one
RJ-45 male connector. See
2. Connect the male connector of the splitter to one of the ISDN ports on an MM720 Media
Module.
Figure 19: RJ-45 splitter wiring for connecting two ISDN BRI stations to one ISDN port
Installation and wiring of telephones and power supplies
Media modules
Figure 19 for the correct wiring for the splitter.
on page 77) supports up to
Issue 8.1 June 2005 337