Avaya g700 Installation And Upgrades page 487

Show image version List for P330 stack processor
Mod Module-Type
------ -----------
3 Avaya G700 media gateway
3 Avaya G700 media gateway
4. Check the version number of the stack software image file in Band B to see if it matches the
your planning document.
If not, you must upgrade the P330 stack processor.
To determine if new firmware is required for the MGP, VoIP module, and installed
media modules
1. Type session mgp
2. At the MG-001-1(super)# prompt, type show mg list_config
The system displays the list of software.
Show MG list_config
SLOT TYPE CODE
---- ------ -----
V0 G700 DAF1
V1 ICC S8300
V2 DCP MM712
V3 ANA MM711
V4 DS1 MM710
3. Refer to the list to check the FW vintage number of the G700.
In the TYPE column, find G700, then check the matching field in the FW VINTAGE column
to see if it matches the vintage number in your planning forms. If not, you must install new
firmware on the G700 media gateway. Also check if the release number in the FW
VINTAGE column contains (A) or (B) to designate the software bank. If the list shows B, you
will upgrade A. If the list shows A, you will upgrade B.
4. Refer to the VOIP FW column and row for slot V0 (same row occupied by the G700
information) to see if the number matches the VoIP firmware identified in your planning
forms.
If not, you must also upgrade the G700 media gateway motherboard VoIP module.
Note:
The VoIP processor on the motherboard is upgraded using the same firmware
Note:
image file as the VoIP media modules; for example, the file mm760v8.fdl is
vintage #8.
SUFFIX HW VINTAGE
------ ----------
A 00
A 00
A 2
A 3
A 1
Install New Firmware on the G700
FW VINTAGE VOIP FW
---------- -------
21.25.0(B) 26
5 N/A
5 N/A
16 N/A
8 N/A
Issue 8.1 June 2005
Bank Version
---- -------
A 0.0.0
B 4.0.17
487