Associating Lsps With Network Regions - Avaya g700 Installation And Upgrades

2. If necessary, complete the fields as described in ''Administration for Network Connectivity
for Avaya Communication Manager, 555-233-504.''
Note:
It is strongly recommended to use the defaults in the screen. However, for the
Note:
RTCP Enabled and RSVP Enabled fields, the entry should be n (no).
3. Press F3 (Enter) to submit the screen.

Associating LSPs with Network Regions

If the primary controller has LSPs, you can associate each LSP with one or more network
regions. In the event of a network failure, IP telephones assigned to a network region will
register with an LSP associated with that region.
This procedure associates up to six LSPs with a network region.
To associate LSPs with a network region
1. On the IP Network Region screen, go to page 2.
IP Network Region Screen, page 2
change ip-network-region 1
INTER-GATEWAY ALTERNATE ROUTING
Incomming LDN Extension:
Conversion to Full Public Number - Delete:
Maximum Number of Trunks to Use:
LSP NAMES IN PRIORITY ORDER
1 node-10-LSP_____
2 ________________
3 ________________
4 ________________
5 ________________
6 ________________
2. Enter the names of up to six LSPs to be associated with region 1.
The LSP names must be the same as administered on the Node Names screen.
3. Submit the form.
4. Repeat for each network region with which you want to associate LSPs.
Administer Communication Manager
IP NETWORK REGION
Insert:
SECURITY PROCEDURES
1 challenge
2
3
4
5
6
Page 2 of 19
Issue 8.1 June 2005 163