H3C S5600 SERIES Operation Manual page 944

To do...
Enable the debugging/log/trap
information terminal display
function
Enable debugging information
terminal display function
Enable log information terminal
display function
Enable trap information
terminal display function
Make sure that the debugging/log/trap information terminal display function is enabled (use the
terminal monitor command) before you enable the corresponding terminal display function by using
the terminal debugging, terminal logging, or terminal trapping command.
Setting to Output System Information to a Log Host
Follow these steps to set to output system information to a log host:
To do...
Enter system view
Enable the information center
Enable information output for a
specified switch in a fabric
Enable system information
output to a log host
Use the command...
terminal monitor
terminal debugging
terminal logging
terminal trapping
Use the command...
system-view
info-center enable
info-center switch-on { unit
unit-id | master | all }
[ debugging | logging |
trapping ]*
info-center loghost
host-ip-addr [ channel
{ channel-number |
channel-name } | facility
local-number ]*
1-12
Remarks
Optional
Enabled by default
Optional
Disabled by default
Optional
Enabled by default
Optional
Enabled by default
Remarks
—
Optional
Enabled by default.
Optional
By default, debugging
information output is enabled,
and log and trap information
output are disabled for the
master switch in a fabric.
Debugging, log and trap
information output are all
disabled for other switches in
the fabric.
Required
By default, the switch does not
output information to the log
host.
After you configure the switch
to output information to the log
host, the switch uses
information channel 2 by
default.