When Switch Acts As Client For Publickey Authentication - H3C S5600 SERIES Operation Manual

Hide thumbs Also See for S5600 SERIES:

Table of Contents

# Create local user client001, and set the authentication password to abc, the login protocol to SSH,

and user command privilege level to 3.

[SwitchB] local-user client001

[SwitchB-luser-client001] password simple abc

[SwitchB-luser-client001] service-type ssh level 3

[SwitchB-luser-client001] quit

# Configure the authentication type of user client001 as password.

[SwitchB] ssh user client001 authentication-type password

Configure Switch A

# Create a VLAN interface on the switch and assign an IP address, which serves as the SSH client's

address in an SSH connection.

<SwitchA> system-view

[SwitchA] interface vlan-interface 1

[SwitchA-Vlan-interface1] ip address 10.165.87.137 255.255.255.0

[SwitchA-Vlan-interface1] quit

# Establish a connection to the server 10.165.87.136.

[SwitchA] ssh2 10.165.87.136

Username: client001

Trying 10.165.87.136 ...

Press CTRL+K to abort

Connected to 10.165.87.136 ...

The Server is not authenticated. Do you continue to access it?(Y/N):y

Do you want to save the server's public key?(Y/N):n

Enter password:

**************************************************************************

Without the owner's prior written consent,

no decompiling or reverse-engineering shall be allowed.

**************************************************************************

When Switch Acts as Client for Publickey Authentication

Network requirements

(SSH Server) for secure data exchange. The user name is client001 and the SSH server's IP address is

10.165.87.136. Publickey authentication is required.

1-30, establish an SSH connection between Switch A (SSH Client) and Switch B

Table of Contents