Acl Configuration Task List; Configuring Time Range - H3C S5600 SERIES Operation Manual

In addition, ACLs defined on S5600 series Ethernet switches can be applied to hardware
directly or referenced by upper-layer software for packet filtering.

ACL Configuration Task List

Complete the following tasks to configure ACL:

Configuring Time Range

Configuring Basic ACL
Configuring Advanced ACL
Configuring Layer 2 ACL
Configuring User-defined ACL
Applying ACL Rules on Ports
Applying ACLs to a VLAN
Configuring Time Range
Time ranges can be used to filter packets. You can specify a time range for each rule in an
ACL. A time range-based ACL takes effect only in specified time ranges. Only after a time
range is configured and the system time is within the time range, can an ACL rule take
effect.
Two types of time ranges are available:
Periodic time range, which recurs periodically on the day or days of the week.
Absolute time range, which takes effect only in a period of time and does not recur.
An absolute time range on an H3C S5600 Series Ethernet Switches can be within the range
1970/1/1 00:00 to 2100/12/31 24:00.
Configuration procedure
Follow these steps to configure a time range:
To do...
Enter system view
Task
Use the command...
system-view
Optional
Required
Required
Required
Required
Required
Required
1-4
Remarks
Remarks
—