Assigning A Unit Name To A Switch; Assigning An Irf Fabric Name To A Switch; Configuring Irf Automatic Fabric For A Switch - H3C S5600 SERIES Operation Manual

To do...
Save the unit ID of each unit in
the IRF fabric

Assigning a Unit Name to a Switch

You can assign a unit name to a switch by performing the operations listed in the following table.
Follow these steps to assign a unit name to a switch:
To do...
Enter system view
Assign a unit name to a switch

Assigning an IRF Fabric Name to a Switch

Only the switches with the same IRF fabric name can form an IRF fabric.
Follow these steps to assign a fabric name to a switch:
To do...
Enter system view
Assign a fabric name to the
switch

Configuring IRF Automatic Fabric for a Switch

Configuration prerequisites
Make sure that the Flash of the newly added device has enough space to download software used
on the device in the fabric.
Configure the fabric port for the newly added device.
Use the command...
fabric save-unit-id
Use the command...
system-view
set unit unit-id name
unit-name
Use the command...
system-view
sysname sysname
1-8
Remarks
Optional
Remarks
—
Required
Remarks
—
Optional
By default, the IRF fabric name
is H3C.