Telnetting To Another Switch From The Current Switch - H3C S5600 SERIES Operation Manual

Hide thumbs Also See for S5600 SERIES:
Table of Contents

Advertisement

4)
Launch Telnet on your PC, with the IP address of VLAN-interface 1 of the switch as the parameter,
as shown in
Figure 3-7 Launch Telnet
5)
If the password authentication mode is specified, enter the password when the Telnet window
displays "Login authentication" and prompts for login password. The CLI prompt (such as
<Sysname>) appears if the password is correct. If all VTY user interfaces of the switch are in use,
you will fail to establish the connection and receive the message that says "All user interfaces are
used, please try later!". A H3C series Ethernet switch can accommodate up to five Telnet
connections at same time.
6)
After successfully Telnetting to the switch, you can configure the switch or display the information
about the switch by executing corresponding commands. You can also type ? at any time for help.
Refer to the relevant parts in this manual for the information about the commands.
A Telnet connection is terminated if you delete or modify the IP address of the VLAN interface in
the Telnet session.
By default, commands of level 0 are available to Telnet users authenticated by password. Refer to
the CLI part for information about command hierarchy.

Telnetting to another Switch from the Current Switch

You can Telnet to another switch from the current switch. In this case, the current switch operates as the
client, and the other operates as the server. If the interconnected Ethernet ports of the two switches are
in the same LAN segment, make sure the IP addresses of the two management VLAN interfaces to
which the two Ethernet ports belong to are of the same network segment, or the route between the two
VLAN interfaces is available.
As shown in
Figure
switch (labeled as Telnet server) by executing the telnet command and then configure it.
Figure 3-8 Network diagram for Telnetting to another switch from the current switch
Figure
3-7.
3-8, after Telnetting to a switch (labeled as Telnet client), you can Telnet to another
3-13

Advertisement

Table of Contents
loading

Table of Contents